49 thoughts on “Twinkie Polymer Clay Tutorial”

  1. Of course you can buy some! check out my store on Etsy 🙂 you can find the store on my website at charmingsculpthers (dot) (com)

  2. I bought mine at either Michael's craft store or Hobby Lobby (not sure which one because I go to both often). You could also check out Dick Blick Art Supplies online. My fav online art supply store!

  3. awesome tutorial, thank you! Also, just wanted to say thank you for adding captions, it's greatly appreciated!! <3

  4. Because twinkies have the holes on the bottom where they inject the frosting filling. There are 3 holes actually, but I took a "bite" out of the twinkie with the cookie cutter.

  5. I use some of my acrylic paint varnishes by Liquitex, however I've seen craft varnishes at Hobby Lobby so I'm sure there are many different kinds you could use. Hope that helps!

  6. White clay mixed with the liquid clay 🙂 On this charm I didn't use any paint, only a clear coating at the end.

  7. awesome thx I have a friend nicknamed twinkie bc she lovs twinkies ima make her dis over summer as a present I hope it turns out well n I hope she likes it thx so much 🙂

  8. @AnissaCharms… Auctually, 15 minutes for 1/4 of a thickness. So it's 2/4 which is why you bake it for 30 minutes.

  9. Anissa, maybe you should read the cooking instructions on the package of the clay you use…Premo states 275 degrees for 30 minutes per 1/4 inch, Sculpey 3 states 275 degrees for 15 minures per 1/4 inch (her charm was clearly larger than 1/4 inch). Fimo Soft states 230 degrees for 30 minutes no measurements listed. So DUH on you….she cooked her charm for the correct amount of time.

Leave a Reply

Your email address will not be published. Required fields are marked *